Press specifications describe the pressing. They do not describe the loading, the folding, the collecting and the scraping, which is where most of the operator's day actually goes — and which is the first thing to break when output doubles.
Each of the four things below exists because of a handling step, not because of a pressing one.
Wider-mouth rosin bags
A bag with a narrow mouth has to be filled carefully, which means filling is slow and operator-dependent, and a spill costs the charge. A wider mouth lets a measured quantity go in directly. It is a small change to the bag and a large change to the cycle, and it is the precondition for filling being mechanised later rather than always being done by hand.
Pre-folded parchment pouches
Folding parchment by hand is the step most likely to be done differently by two people. A fold that is uneven leaks, and one that is creased in the wrong place tears under pressure and takes the collection with it. A pouch that arrives folded removes the variable rather than training it.
Several bags in one press cycle
The handling cost of a press cycle is roughly fixed regardless of how much is in it. Pressing several bags together under one pressure and temperature spends that fixed cost once instead of several times — and because they share the same plates, they share the same conditions, which is one fewer reason for two batches to come out different.
Flow control into the collection cavity
Rosin that spreads across a sheet has to be scraped back together, and scraping is where material is lost and where a sheet gets torn. Directing the flow into a defined cavity means the rosin arrives where it is going to be collected from. The gain is in what you do not lose and do not have to clean up.
The pattern
None of these makes the press press harder. They each remove a step where an operator's technique could change the result — which is what has to happen before a process can be run by a team rather than by a specialist.