Washing separates the fine material from the source material by moving both through cold water. The whole result depends on how that movement is applied, because the fine material is fragile and the source material is not. Too little energy and it stays attached. Too much, or the wrong kind, and it breaks up and goes through the screens with everything else.
That is a narrow window, and most agitation equipment was not built to sit in it.
The problem with stirring
A vortex pulls material into a fast centre and leaves the edges slow. The energy delivered to a given piece of material depends on where it happens to be in the vessel, so a single vessel runs several different processes at once — over-worked in the middle, under-worked at the wall — and the operator can only choose an average.
What the Smart Agitator does differently
A three-layer paddle covering the vessel's internal diameter, top to bottom. The point is not more agitation but *even* agitation: material at the wall and material at the centre see comparable energy, so the vessel runs one process instead of a gradient.
A servo motor and planetary gearbox. This is what makes agitation a set of values rather than a speed dial. Speed, acceleration, deceleration and pause time are each specified, so a cycle can be shaped — worked, then rested, then worked again — and written down as a recipe that runs the same way next week.
A working range of 28–32°F, without ice in the vessel. Ice is a blunt instrument: it cools by melting, which means it also dilutes, adds volume, and changes the mechanical environment as it goes. Holding the temperature directly keeps the cold stable through the cycle and keeps what is in the vessel to water and material.
Where it sits in the line
The agitator handles the washing stage; after it the material is filtered through a graded bag set and dried, and then pressed. Our freeze dryers handle the drying stage, and the KWÄD press the pressing stage — its plate pressure runs 0–2,500 psi at the bag, depending on effective pressing area — about 1,400 psi across the full 12×12″ platen, and its trapezoid bags let several batches press together under one pressure and temperature.
The reason to care about the parameter list is not the parameters. It is that a process defined by values can be repeated, taught and corrected, and a process defined by feel cannot.